Page 1 of 1

Admin-auto-disconnect

PostPosted: Thu Jan 28, 2016 7:12 am
by killah
hello everyone
i had i little crash with my serveur since that day my admin session can't remain more thant 2 min without being disconnected
also it remain like 1 or 2 min before acces in admin session
i type those below cmd but always the same

mysqlcheck -u root -p --auto-repair --check --optimize --all-databases
mysqlcheck -u cron -p1234 --auto-repair --all-databases

can someone help me???
note:agent seesion is good i dont have problem about it
thx

Re: Admin-auto-disconnect

PostPosted: Sat Jul 23, 2016 7:18 pm
by williamconley
1) Welcome to the Party! 8-)

2) As you are obviously new here, I have some suggestions to help us all help you:

When you post, please post your entire configuration including (but not limited to) your installation method (7.X.X?) and vicidial version with build (VERSION: 2.X-XXXx ... BUILD: #####-####).

This IS a requirement for posting along with reading the stickies (at the top of each forum) and the manager's manual (available on EFLO.net, both free and paid versions)

You should also post: Asterisk version, telephony hardware (model number is helpful here), cluster information if you have one, and whether any other software is installed in the box. If your installation method is "manual/from scratch" you must post your operating system with version (and the .iso version from which you installed your original operating system) plus a link to the installation instructions you used. If your installation is "Hosted" list the site name of the host.

If this is a "Cloud" or "Virtual" server, please note the technology involved along with the version of that techology (ie: VMware Server Version 2.0.2). If it is not, merely stating the Motherboard model # and CPU would be helpful.

Similar to This:

Vicibox X.X from .iso | Vicidial X.X.X-XXX Build XXXXXX-XXXX | Asterisk X.X.X | Single Server | No Digium/Sangoma Hardware | No Extra Software After Installation | Intel DG35EC | Core2Quad Q6600

3) You said you typed those commands, but you did not mention the results of those commands.

4) Are you accessing from the same location as your agents, or a different location?