Setting Up Vicidial Remotely
Moderators: gerski, enjay, williamconley, Op3r, Staydog, gardo, mflorell, MJCoate, mcargile, Kumba, Michael_N
4 posts
• Page 1 of 1
Setting Up Vicidial Remotely
by ykhan » Tue Dec 11, 2007 6:46 pm
I need to setup a server remotely. How can I go about installing Slackware on a remote machine? Thanks.
- ykhan
- Posts: 352
- Joined: Thu Jun 08, 2006 4:47 pm
by mflorell » Tue Dec 11, 2007 11:11 pm
Try following the SCRATCH_INSTALL guide:
http://astguiclient.sourceforge.net/scr ... stall.html
http://astguiclient.sourceforge.net/scr ... stall.html
- mflorell
- Site Admin
- Posts: 18339
- Joined: Wed Jun 07, 2006 2:45 pm
- Location: Florida
by ykhan » Wed Dec 12, 2007 1:26 am
I have previously setup a number of servers using the scratch install guide, some of them being remote after installation of Slackware. In this case, I cannot physically be at the site and need to give someone without any knowledge of setting up linux a small CD by which they can boot the machine and then give it a network address. Following this process, I can take over and follow the scratch install. Is there a boot CD that can help me to do this out there? Thanks for any help. 
- ykhan
- Posts: 352
- Joined: Thu Jun 08, 2006 4:47 pm
by ramindia » Wed Dec 12, 2007 2:33 am
Hi
this case you need to have Ip based console
so you can see right from boot bios.
any distro with PXE enable will do the basic job.
or download debian 30MB Image, or any other single CD
ram
this case you need to have Ip based console
so you can see right from boot bios.
any distro with PXE enable will do the basic job.
or download debian 30MB Image, or any other single CD
ram
Kindly post your feedback, if this solution works.
so its very usefull for others who join later as a NEWBIE.
so its very usefull for others who join later as a NEWBIE.
- ramindia
- Posts: 688
- Joined: Wed Oct 11, 2006 4:06 am
- Location: India
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 213 guests