Amfeltec Voice Sync Timers

[Acidshock]

Hi Everyone,

Quick question. Is there a package or script already created for Vicibox 5.0.3 that installs the Amfeltec Voice timers drivers? I don't see the driver using lsmod and dahdi doesn't detect it.

[Acidshock]

Forgot to mention post the specs regarding this particular deployment:

VERSION: 2.8-431a | BUILD: 140314-1134 | 1.8.23.0-vici | Vicibox 5.0.3

[mflorell]

viewtopic.php?f=4&t=32793

[Acidshock]

Hi Matt,

I saw that post yesterday. Unfortunately the drivers are not being loaded. I am seeing the card though via lspci.

vd-02:~ # lspci | grep Exar
0a:02.0 Serial controller: Exar Corp. Device 0301 (rev 02)
vd-02:~ # lsmod | grep voicesync
vd-02:~ #

[mflorell]

Did you install the amfeltec PCIexpress card before installing Vicibox?

[Acidshock]

After. I figure there is probably a package I need to zypper in that wasn't included during the normal install however I am not sure what that may be.

[Acidshock]

Anyone know the package(s)? I am reluctant to try to compile it since we are now package based with 5.0.3

[Kumba]

You need to edit the default Vicidial init script to load the proper drivers. The init script is located at /etc/init.d/vicidial

You would look for the ZAP_MOD=dahdi_dummy line and replace dahdi_dummy with voicesync.

Alternatively, as a short cut, you can run the following command after loggin in as root: sed -i 's/ZAP_MOD=dahdi_dummy/ZAP_MOD=voicesync/' vicidial

Once you have modified the init script, just type reboot to verify that the driver loads on boot properly.